Time: 15 minutes
Tools for the job:
- Rag
- plastic cap from the handle
- head on a 9 mm
- The head of 11 mm
- Spanner wrench 15 mm or 6 mm hex
- Grease Motorex Bike Grease 2000
- A small flat screwdriver
Price:
- Approximately $ 10 for lithium grease for the bearings (enough for a lot of the bulkhead)
1. Most contact the pedals are held on the nut with a lock nut, located under a plastic cover. It can get, podsunuv under her head screwdriver or knife blade.
2. uses 9-millimeter head to loosen the lock nut, and 15-mm key hold the axle so that it does not rotate. After removing the cone of 11-millimeter head and try not to lose the bearings. If the head does not fit in the pedal, try to keep the cone with a screwdriver and rotate the axle on the other side. Some Pedal Type Shimano PDM959 (XTR) dealt with the side of the axis. For their dismantling will only need a pipe wrench, which need to unscrew the plastic nut between the body and axis.
3. Carefully remove the axle from the housing pedal. Try nothing to lose. Extract all the balls remaining in the body, and remove from the axis of anther, remembering, as he stood. Then remove the remains of grease from the axle and the body.
4. Apply axle and bearing cups lithium grease, and then expand in places balls. Do not confuse the number! And do not forget to pre-cleaned.
5. Install the new duster and carefully paste the axle housing.
6. Stick axis in the sequence, reverse disassembly. Adjust the tightness of the cone so that the pedal rotates easily and smoothly, but without a backlash. Tighten the pedal back to the connecting rod and go skate ...
Tips mechanics:
When the ball lay on the bearing cup, use the plastic cap of a ballpoint pen. It's much more convenient screwdriver or any other iron, and accordingly Magnetizable and tools.
Material published in the Mountain Bike # 16 (sentyabr'06)!
0 comments:
Post a Comment