Tuesday, July 7, 2009

How To Build Wakeboard Kicker

Install hydraulic disc brakes.

Installation hydraulic disc brakes on a bicycle.


Hours: half hour

Cost: Will spend about $ 100 to clamp and lock the thread (and, of course, here priplyusuet value of disc brakes, if you have not yet bought)

Tools: cutters hose, clamps, Allen 5 mm, lock the thread (like Loctite)

Tips mechanics:

-Before you start to hang on the frame of other equipment Turn to seal the rear hydraulic line. Remember: like twigs fall into any of the loop. At dvuhpodvesnoy frame check with full compression the rear suspension, not to was sticking out of bends.
-If you're not sure what to put the brakes as necessary (their proper installation is required for your own safety), then head for the nearest Bikes. Hopefully, a few strokes of the wrench with you there are not prompted for an exorbitant price. When will put the brakes, look sharp and remember, the next time you are able to do everything himself.

a . Remove the old brake and clean them. Useful in the economy: it is useful to always have on hand a spare Set the brakes just in case if you have any problems with the hydraulic disc that you can not resolve until the next trip.

2. Put on the wheel brake lever, check to see whether confused right from the left. If the new brake lever, as compared with the covers, longer or shorter, then you have to adjust the mounting knob on the steering wheel so that the stylus arm rose in the right place. In this case, you may have to move the control stick switches a few millimeters inside.


3 . If it becomes necessary to use an adapter for the caliper (it requires many forks with mounting Standard post-mount, such as Manitou and Marzocchi), it means that it was the turn for the installation. Bolts on most cards come with already applied thread lock (this is determined by the way they are plastered with red or blue sticky substance). If they do not lock the thread, do not forget his cause: unlikely you in the middle of the descent like rattle loose bolts.


4. Now set the calipers to the frame / fork. On some models, adapter, or on the body of the caliper instead of round holes for the bolts used extended along the slit. This allows you to make an exact fit. Other manufacturers, such as Hope, offer You tinker with washers and spacers, which are supplied in different sizes. Do not hurry, do the procedure carefully, because rubbing wheels is not so much slow down your movement, how many would get their creaking and you and those who will go near you.


5. Put disc brakes on the hub and secured using the screws - it does not take much time. Just check that bolts do not remove and they were locking the thread. If the bolts for the rotors equipped with exotic heads, it is better to change them on a hexagon bolts - then there will be problems with the tool, and check them for tightness easier. If you have a brake Shimano, it's likely they have a system fastener Center Lock: drive is put on the guide pins and tighten the nuts in the same way as the rear cassette, - Puller tape.


6. With clamps Attach hose to the frame. Some frames come with a hydraulic line guides - specific projections with small holes for the clamp to pinch the hose in it. On the other tabs are used as hooks where to twist the hose to put it in place. Be more careful with it: it is easy to twist the hose (unless it is reinforced with metal, an upgrade is very significant). But before fasten the hose, first Experiment with the options of laying to find the most elegant way of steering the wheels.


material published in Mountain Bike # 8 (noyabr'05)

0 comments:

Post a Comment