Engineers - Designers bike, developing a new model of bike, guided by a categories of consumers. Unfortunately, about a category as Cyclists are often overlooked. Some argue that for cycling, there are touring bikes and hybrids. But touring bike, is in essence, a kind of highway that is intended primarily for good roads (but good road Cyclists dislike, because they are a lot of cars) to purchase the same hybrid in the contemporary Russian situation is not quite easy (although the situation is gradually changing for the better).
most common type of bicycle is now a mountain, mountain biking. As a result, many Cyclists use in campaigns bikes of this type. Their versatility, low weight, high permeability, high ground clearance and good handling on bad roads provide high popularity of mountain biking.
And for cyclists is one of the most important pieces of a bicycle - trunk. It is clear that on a bike - dvuhpodves trunk do not deliver, so cycling is used mainly Hard Tail. But often, designers Hard Tail medium upper price categories and for some reason assume that their product will be used only by competition and forget about the trunk.
When installing luggage on a bike with disc brakes often stalkivavatsya with the problem - the luggage rack is in contradiction with caliper brakes. Then is the frame has holes for fastening the boot, carving them sliced, but when you try to install the boot of his stand must go through the caliper. Byvat and worse - the frame does not provide any sort of holes for the trunk. Drilling new holes in the same frame is not recommended, it leads to loss of warranty.
As a result, we often hear that the bike with disc brakes can not be used in cycling. Advised to withdraw from the situation by applying cantilever rack, fastened to the seat tube, or carry the whole load in the rucksack (podramnoy bag). But none of these methods can not be called suitable for multi-day hike.
Attention! It happens that to secure the trunk to the frame is missing some fraction of a millimeter. In no case do not try to modify a file caliper disc brakes - the wall of the working cylinder may be surprisingly thin, and a product with rather big price irredeemably flawed! Desirable also to counter the trunk touched any parts brake system.
turns out, the trunk on the bike with disc brakes supply still can. And even in several ways.
first method - applicable if the frame has holes for the trunk. The idea is simple - move the trunk back to its stand did not touch the caliper, and that before he could get at service brakes (brake pads all still need to be changed and brake fluid - too).
This will require the holder to manufacture something like this form.
I made it out of steel corner. Cut down too much, leaving only the rib. This required Bulgarian and metalwork skills. And installed it on the bike. Mounting happened rigid, and the trunk is not walking from side to side.
The result - a completely satisfactory. The design is operated during the year stood 25 kg backpack in a ten Bicycle Tours (1 KS), and a large number of one - two - trehnevnyh hikes of the day. Complaints yet.
not excluded, of course, that on a different model bike and trunk shape bracket would have to change. In general, show ingenuity.
second method will be used If no holes for the trunk in the frame no. (And what looked when buying a bicycle?)
If the frame is no holes for the trunk, you'll need to use clamps. The trunk is attached to the collar, around the feathers back forks and seat tube. To clamp should be used sheet thickness 1-1.5 mm. To avoid scratches frame, a clamp is put a rubber strip, cut from inner tube.
Mounting got tough enough, though not as both brackets.
holder of this type also successfully withstood several multi-day hikes, no complaints on them there.
Taken here .
0 comments:
Post a Comment