Adjusting front derailleur is possible only after a fully configured rear.
Before adjustment does not hurt to check state of the tether. If the cable is frayed or Untwist it is better to replace it. And if it is dirty, then it must be cleaned and lubricated. Not greased rope can cause fuzzy gearshift.
preparation.
set the chain on the smallest sprocket at the front and the largest rear. Is in its switch adjusting screw H (High) and L (Low). Weaken the screw cable.
on the control stick to rotate the drum cable tension adjustment clockwise until it stops (if is).
small adjustment programs.
turning the screw, L (Low), set the scope of such provision to the chain is as close as possible to the internal plate, but that when pedaling the chain will not hit the scope.
Then We stretch rope and wrap the cable fixing screw.
Adjustment large transfers
translate the chain on the largest front and smallest rear sprocket rotating screw H (High), establish a position frame to the chain is as close as possible to the outside of the plate, but that when pedaling the chain will not hit the scope.
Check switch operation. This is best done under load, that is just to ride a bike. The chain should move from one sprocket to another smoothly and quickly, and thus should not affect the scope of the switch. If hurt, you have to check the parallelism of the frame and sprocket (maybe switch installed correctly), and the state own star system (perhaps they are deformed).
0 comments:
Post a Comment